features low forward voltage drop fast switching for high efficiency high current capability case: heatsink to-220ab high surge current capability weight: 2.1 gram approxiamtely polarity: as marked on diode body method 208 mounting position: any terminals: solderable per mil-std-202 mechanical data low reverse leakage current epoxy: ul 94v-0 rate flame retardant pb free plating product fr1001ct thru fr1007ct application automotive inverters/solar inverters plating power supply,smps and ups car audio amplifiers and sound device systems pb 10.0 ampere heatsink dual common cathode fast recovery rectifiers .196(5.00) .054(1.39) .038(0.96) .419(10.66) .139(3.55) min .624(15.87) .269(6.85) .548(13.93) .50(12.7)min .177(4.5)max .226(5.75) .163(4.16) .045(1.15) .019(0.50) .025(0.65)max .1(2.54) .1(2.54) .387(9.85) to-220ab unit : inch (mm) fr1001ct thru fr1007ct ? 2006 thinki semiconductor co., ltd. http://www.thinkisemi.com/ page 1/2 rev.07c positive negative common cathode case case common anode doubler case tandem polarity case series tandem polarity suffix "a" suffix "d" suffix "s" suffix "ct" maximum ratings and electrical characteristics ratings at 25 ambient temperature unless otherwise specified. single phase, half wave, 60h z , resistive or inductive load. for capacitive load, derate current by 20%. symbols units maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 volts maximum rms voltage v rms 35 70 140 280 420 560 700 volts maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 volts maximum average forward rectified current see fig. 2 peak forward surge current, 8.3ms single half-sine-wave superimposed on rated load (jedec method) maximum forward voltage at 5.0a dc and 25 maximum reverse current at t c =25 at rated dc blocking voltage t c =125 typical thermal resistance (note 1) r jc /w maximum reverse recovery time (note 2) t rr 250 ns operating and storage temperature range t j tstg notes: 1- thermal resistance from junction to case per leg mounted on heatsink. 2- reverse recovery test conditions i f =.5a i r =1a i rr =.25a. i r amp amp volts uamp 1.3 i (av) i fsm v f 10.0 125 -55 to +150 5.0 100 3 150 500 fr1001ct fr1002ct fr1003ct fr1004ct fr1005ct fr1006ct fr1007ct
ratings and characteristic curves ? 2006 thinki semiconductor co., ltd. http://www.thinkisemi.com/ page 2/2 rev.07c fr1001ct thru fr1007ct
|
